MPC-FORUM.EU

Setting the Autoload Function
In default, the autoload function, which loads the preset sounds and demo sequence automatically when you switch on the MPC500, is
activated. You can deactivate this function so that the MPC500 will not load anything when switched on.
1. In the 'Type' field, choose Load.
2. In the 'Selection' field, choose Autoload.
The Load Setup window will be displayed.
On - When powered on, the data of internal flash memory is automatically loaded.
Off - When powered on, the data of internal flash memory is not automatically loaded.
3. To turn off autoload, set the 'Autoload' field to OFF. The next time you switch on the MPC500, it will not load
anything.
Tip: When you insert the memory card which has an AUTOLOAD folder, into the card slot and switch on the MPC500, the MPC500 will
load the AUTOLOAD folder in the memory card automatically, regardless of the settings in the 'Autoload' field.

Creating the Autoload Folder
When you create an AUTOLOAD folder on the memory card, the MPC500 will load the contents of the AUTOLOAD folder automatically
when you switch on the unit with the memory card in the card slot. You can load the most frequently used drum set program or sequence
data automatically.
1. In the 'Select' field, choose Entire Mem. The following screen will be displayed.
2. In the 'Parameter' field, choose Autoload and press the [DO IT] button.
The MPC500 will create the AUTOLOAD folder in the ROOT folder and save all the data in that folder. If the ROOT folder already has the
AUTOLOAD folder, the Autoload Folder Exists window will be displayed.
To replace the current AUTOLOAD folder with a new one, press the [DO IT] button. In this case, the contents of the current AUTOLOAD
folder will be deleted.
To keep the current AUTOLOAD folder, press the [CANCEL] button to cancel the operation.
The MPC500 will start saving the data.